TM9-2815-202-34 4-42.  GOVERNOR   REPAIR    (Cont) (30)  Install  riser  (48)  on  shaft  of  weight  carrier  assembly  (43). NOTE Incorrect installation of riser thrust bearing will result in erratic operation of governor. (31 ) Install riser bearing (47) with smaller inside diameter against riser (48) on weight carrier (32) (33) (34) (35) (36) (37) (38) (39) (40) assembly  (43). Insert weight carrier assembly (43) in governor housing (3). Support spline end of shaft and governor  housing  on  arbor  press  bed. Place weight carrier bearing (46) in governor housing (3) with number side up. Place a 1/2 inch diameter sleeve on top of inner race of bearing (46) and press into governor housing (3) and against shoulder of shaft on weight carrier assembly (43). Clamp  spline  end  of  weight  carrier assembly  (43)  in  soft-jawed  vise. Place key washer (41 ) on end of weight  carrier  assembly  (43)  with  tang on inner diameter of washer in notch in end of carrier shaft. Install  washer  (44)  and  retaining  bolt (42), Torque bolt to 15-19 Ib-ft (20-26 N-m). Bend tang on key washer (41) against head of bolt. Install  washer  (40)  against  bearing (46). Apply sealant to threads of plug (39) and  install  in  governor  housing  (3). Torque plug to 45 Ib-ft (61 N-m). Place seat (38) and high speed spring (37) on plunger (30). Thread  screw  (35)  one-half  inch  into threaded end of plunger (30) and install nut (36) onto screw until it contacts  end  of  plunger, Place low speed spring (32) into low (41) speed   spring   cap   (31). (42) Place small end of spring seat (33) into low speed spring (32). Place adjusting pin (34) into spring seat. (43) Install adjusting pin (34), (31) into plunger (30). spring seat (33), low speed spring (32), and low speed spring cap 4 - 2 5 8