TM    9-2815-202-34 5-20.   CAMSHAFT b. Inspection FRONT  GEAR  COVER  AND   DAMPER   REPLACEMENT   (Cont) Inspect front gear cover and damper for cracks, pitting, or damage. c. Installation (1) (2) (3) (4) (5) (6) (7) (8) (9) (lo) If removed, install seal (23) into front gear cover (13). Position seal with lip facing inward. Using seal installer, drive seal into cover until installer is flush with cover. NOTE Assemble top three bolts with nuts toward front of engine. Position front gear cover (13) and gasket (21) on front end plate (22). Secure with five bolts (10), five flat washers (12), five Iockwashers (2), and four nuts (11) at top of cover. Install bolt (10), flat washer (12), Iockwasher (2), and jam nut (14) at lower left corner of cover. Install bolt (15), Iockwasher (16), and flat washer (17). Install two bolts (18), two Iockwashers (2), and two flat washers (12). Install two bolts (19) and two flat washers (20). Install bolt (8) and flat washer (9). Torque two bolts (18) to 30-35 Ib-ft (41 -47 N-m). Torque six bolts (10) to 35-39 Ib-ft (47-53 N-m). Torque bolt (15) and bolt (8) to 71-75 Ib-ft (96-102 N-m). Torque two bolts (19) to 137-147 Ib-ft (186-200  N-m). Install woodruff key (7) into shaft pulley drive (5). Aline keyway in damper (4) with woodruff key on shaft pulley drive and install damper. Secure damper (4) to shaft pulley drive (5) with bolt (1), Iockwasher (2), and flat washer (3). Torque bolt to 30-35 Ib-ft (41-47 N-m). END OF TASK FOLLOW-ON  MAINTENANCE Para   Description 5-7 Install water pump 5-26