TM   9-2815   -202-34 (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) Remove  spacer  (10),  retaining  ring (11), and two washers (12) from speed  control  shaft  (13). Remove speed control shaft (13) from governor  cover  (2). Remove seal ring (14) from governor cover (2). Discard seal ring (14). Support  governor  cover  (2)  on wooden blocks in a press, top facing down. Using  bushing  remover  (15),  remove two control shaft bushings (16) from governor  cover  (2). Place governor housing (3) in soft- jawed  vise. Remove two bolts (17) and two flat washers  (18)  securing  access  cover (19) and gasket (20) to governor housing  (3).  Discard  gasket. Loosen  retainer  nut  (21)  and  remove high  speed  spring  retainer  (22), retainer nut (21), and plunger (23) assembly  from  governor  housing  (3). Remove low speed spring cap (24), low speed spring (25) spring seat (26), and adjusting pin (27) from plunger (23). Using a socket head wrench, hold screw (28) and loosen nut (29). WARNING High  speed  spring  is  under pressure,  and  personal  injury could occur if downward pressure Is not applied to retainer. (15) While applying pressure to high speed  spring  (30),  remove  screw  (28) from  plunger  (23). (16) Remove high speed spring (30) from plunger  (23). 5 - 65