TM   9-2815-202-34 5-41.   GOVERNOR   REPAIR   (Cont) (38) (39) (40) (41) (42) (43) (44) (45) (46) (47) (48) Remove  expansion  plug  (75)  from  bottom  of  governor  housing  (3).  Discard  expansion  plug. Remove  operating  shaft  upper  bearing  retainer  screw  and  washer  assembly  (76)  and  flat washer (77) securing bearing in governor housing (3). Place governor housing (3) in press, bottom side up. Press operating shaft (78) out of lower bearing (79) located in governor housing (3). Place a 9/16-inch open end wrench (80) under operating fork (81) and press fork off operating  shaft  (78). Remove  spacer  (82),  operating  shaft  (78),  upper  operating  lever  bearing  (83),  and  operating Iever (61) from governor housing (3). Slide spacer (82) from shaft (78). When  pressing  operating  shaft  from  operating  lever  and  bearing,  catch  shaft  by  hand  to prevent  it  from  falling  and  being  damaged. Press operating shaft (78) from upper bearing (83) and operating lever (61). Loosen  locknut  (84)  and  remove adjusting  screw  (85). If damaged, remove pin (59) from operating lever (61 ). Press lower bearing (79) from governor housing (3). For models 7083-7391 and 7083-7396 ---- only, hold starting aid screw (86) and remove nut (87) from governor housing External  starting  aid  screw  is removed by screwing inward through governor housing. Removing  the  screw  outward through the governor housing will damage  the  threads  in  the  housing due to oversize button on end. (49) For models 7083-7391 and 7083-7396 only, remove external starting aid screw (86) through governor housing (3) by (3). turning  screw  clockwise. 5-68 C h a n g e    1