TM9-2815-202-34 8-11.  MAXIMUM  NO  LOAD  SPEED  ADJUSTMENT  (DUAL  RANGE  LIMITING  SPEED GOVERNOR) This taskcovers:   Adjustment INITIAL   SETUP MODELS MANDATORY   REPLACEMENT   PARTS 7083-7395 7083-7398 TOOLSANDSPECIAL   TOOLS General mechanics tool kit  (App B, Item 96) Turbocharger inlet shield  (App B,ltem 81) 2 Lockwashers  (App F, Item 92) 2 Gaskets  (App F, Item 78) l EQUIPMENT   CONDITION Para   Description 8-6 Governor  spring  housing & cover  removed 8-6 Buffer screw backed out Adjustment NOTE l l l Buffer screw must project 0.625 inch from locknut to prevent interference while adjusting  the  maximum  No  Load  speed. If the engine has not been adjusted since overhaul, insure four 0.100 inch shims (1) and four 0.010 inch shims (2) should be in governor spring housing piston (3). Maximum low speed screw (4) should extend from spring housing cover (5) 1.25 a. b. inch. Install governor spring housing (6), cover (5), two gaskets (7), two  Iockwashers  (8), and two bolts (9) on governor housing (10). . Connect oil or air supply line to governor spring housing (6). l l l WARNING Avoid contact with hot manifolds, pulleys, and other moving parts to avoid  personal  injury. Wear  proper  ear  protection  when  running  engine.  Noise  volume  of engine  can  cause  hearing  loss  or  Injury. Protective  turbocharger  air  Inlet  shield  must  be  Installed  prior  to  doing maintenance  when  engine  Is  running  and  air  inlet  has  been  removed. Contact  with  rotating  blades  will  cause  injury  to  personnel. 8-26