TM9-2815-202=34 8-16.  FUEL  PRESSURE Thistask  covers: Testing TEST l INITIAL   SETUP MODELS EQUIPMENT   CONDITION Para   Description 4-11 Rocker arm covers removed TOOLS  AND  SPECIAL  TOOLS l General  mechanics  tool  kit  (App B, Item 96) Fuel pressure gage  (App B, Item 31) Fuel nut wrench  (App B, Item 99) Turbocharger inlet shield (App B, Item 81) Torque  wrench  (App B, Item 100) Testing a. Remove fuel inlet tube (l) from injector (2)andfuel  inlet manifold(3). b. Connect pressure gage (4)toinjector  (2)and fuel manifold(3). WARNING Avoid contact with hot manifolds, pulleys, and other moving parts to avoid  personal  injury. Wear  proper  ear  protection  when  running  engine.  Noise  volume  of engine  can  cause  hearing  loss  or  injury. Protective  turbocharger  air  inlet  shield  must  be  installed  prior  to  doing maintenance  when  e-ngine   is  running  and  air  inlet  has  been  removed  .- Contact  with  rotating  blades  will  cause  injury  to  personnel. CAUTION Run engine in clean area when air intake  ducting  is  removed.  Dirt,  dust,  and  particles in  unfiltered  air  can  enter  engine  and  damage  parts  or  cause  mechanical  failure. c. Start engine and operate at 1800 RPM. Note reading on fuel pressure gage (4). Fuel pressure must be 50-70 PSI (345-482  kPa) at 1800 RPM. d. Move governor stop lever (5) to NO-FUEL position to stop engine. b 8-40 Change  1