INSTALLATION (Continued) - TM-9-2815-220-240243

Custom Search

Back
INSTALLATION (Continued)

Up
TM-9-2815-220-24 Maintenance Manual for AVDS-1790 2CA 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

Next
FUEL INJECTION PUMP TIMING CHECK

TM 9-2815-220-24

INTAKE AND EXHAUST VALVE TIMING PROCEDURE

0035 00

INSTALLATION (Continued)

5. Adjust intake valve (8) clearance (0.010 inch, 0.254 mm).

a. Loosen intake valve adjusting screw lock nut (10).

b. Turn valve adjusting screw (11) until clearance between valve adjusting screw pad (12)

and valve stem is 0.010 inch using thickness gauge blade (13) (item 55, WP 0176). Gauge

blade must move through clearance with a slight drag.

c. Check position of valve adjusting screw pad (12) to make sure seat is flat on valve stem.

d. Torque lock nut (10) to 200-225 inch-pounds (23-25 Nm) after correct adjustment is

made. Make certain setting has not changed after tightening lock nut (10).

6. Install intake valve adjustment cover (3).

a. Using new gasket (6) (item 350, WP 0175), install cover (3).

b. Secure with two bolts (4) and flat washers (5).

7. Install timing access cover (1).

a. Secure with three cap screws (2).

2 (3 places)

END OF WORK PACKAGE

WP 0035 00-13 (14 blank)