| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
OIL LEVEL GAUGE ROD REPLACEMENT/REPAIR
0076 00
DISASSEMBLY
1. Remove oil level indicator tube neck (13).
21
a. Remove two cap screws (14) with lock
20
washers (15). Discard lock washers.
19
b. Remove and discard gasket (16) and two
O-rings (17).
2. Remove spring (18).
18
3. Remove and discard preformed packing (19).
13
NOTE
Do not remove two cap screws (20)
16
20
fastening cap (21) to neck (13)
17
unless inspection indicates
replacement is necessary. The
screws are staked in place.
3. If necessary, remove two cap screws (20).
CLEANING
15
1. See Work Package 0028 for Standard
14
Cleaning Procedures.
INSPECTION
All parts must be inspected with care. Replace parts if damage or wear exceeds allowable
limits.
1. See Work Package 0028 for Standard Inspection Procedures.
ASSEMBLY
1. Install new preformed packing (19) (item 285, WP 0175) in cap (21).
2. Assemble cap (21) to neck (13).
a. Position cap (21) over tabs on neck (13) and secure with two screws (20).
b. Snug-tighten two screws (20) so that cap (21) can open and close freely.
c. Stake two screws (20) in place.
3. Install spring (18).
WP 0076 00-4
|
||
|
||
