| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
CYLINDER OIL DRAIN TUBES REPLACEMENT
0077 00
INSTALLATION
1. Assemble left bank oil drain tube assembly (43).
a. Lubricate inside of new hoses (47) (item 313, WP 0175) with lubricating oil (item 21,
b. Place clamp (46) on inboard end of tube (48) and position towards fluid passage bolt hole
to allow installation of hose (47).
c. Install hose (47) on inboard end of tube (48) and position it about half way onto tube.
d. Place clamp (46) on inter-cylinder tube (49) and position it towards fluid passage bolt hole.
e. Insert tube (49) approximately half way into opposite end of hose (47).
f. Repeat procedure for remaining inter-cylinder tubes (49) and end tube (50), leaving
clamps (46) loose.
2. Install left bank oil drain tube assembly (43) onto engine.
a. Position a new lubricated gasket (45) (item 283, WP 0175) top and bottom of each tube
(48, 49, 50) and secure at each cylinder with a fluid passage bolt (44).
b. Center hoses (47) at each location and secure with clamps (46).
c. Torque-tighten fluid passage bolts to 275-300 inch pounds (31-34 Nm).
43
48
LEFT BANK OIL DRAIN
49
47
46
45
44
50
FLYWHEEL END
DAMPER END
WP 0077 00-7
|
||
|
||
