| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
FUEL/WATER SEPARATOR REPAIR/FILTER ELEMENT REPLACEMENT
0085 00
INSTALLATION
1. Install water separator (4).
a. Place separator in position and loosely secure using three mounting screws (13, 17) with
flat washers (15) and new lock washers (14) (item 93, WP 0175), leaving space between
water separator (4) and mounting bracket (18).
CAUTION
Probes must be installed in proper separator ports. Probe with lead
attached to side of control module must be installed in upper
separator port. Failure to comply will result in improper functioning
of fuel/water separator.
2. Install two water level probes (11, 12).
a. Install two water level probes (11, 12) in fuel water separator (4).
b. Install screw (13), new lock washer (14) (item 93, WP 0175), flat washer (15), and
cushioned clamp (16).
c. Tighten remaining mounting screws (13, 17).
18
Control
Module
4
Lower
Probe
4
Upper
Probe
17
13
11
17
12
16
15
14
13
WP 0085 00-7
|
||
|
||
