| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS
REPLACE/REPAIR (2DR)
0123 00
ADJUSTMENT
1. With the throttle linkage in full throttle position (A), clearance between stop pin of remote
control lever (8) and pump drive adapter assembly (14) must be 1/8 inch (3.175 mm) nominal.
2. With the throttle linkage in idle position (B), clearance between stop pin of remote control
lever (8) and pump drive adapter assembly (14) must be 3/16 inch (4.7625 mm) minimum.
3. When the foregoing clearances are not met, loosen lock nuts (77, right-hand thread) and (78,
left-hand thread) on control rod assembly (4), and adjust as necessary to obtain required
clearance.
4. Tighten lock nuts (77 and 78) after adjustment.
Idle Adjustment
Stop
Stop
Pin
Pin
28
78
77
4
28
Idle Position
Full Throttle
Solenoid Speed Control
Remote Control Lever
56
56
8
8
B
A Pin
Pin
Idle Position Full Throttle
14
14
Idle Position
Full Throttle
NOTE
Engine idle adjustment and solenoid speed control adjustments are
made with the engine running. Engine idle is controlled with the idle
adjustment screw (28), and solenoid speed control is adjusted with
solenoid speed adjustment screw (56). See Work Package 0043.
END OF WORK PACKAGE
WP 0123 00-17 (18 blank)
|
||
|
||
