TM 9-2815-225-34&P 3-34.  ENGINE BLOCK REPAIR (Contd) LOCATION/ITEM ACTION REMARKS d.  Assembly (Contd) 38.     Cap (25) Install on rear of engine block (14).   Use suitable plug driver and pipe sealant around outside diameter of cap (25). 39.     Fourteen screws (18), Install loosely on engine block (14).   Bearing caps will be removed at washers (17), No. 7 bearing assembly during crankshaft cap (19), No. 2, 4, and 6 installation. bearing caps (20), and No. 1, 3, and 5 bearing caps (21) FOLLOW-ON TASKS: Install engine crankshaft and main bearings (para. 3-68). Install pistons, connecting rods, and bearings (para. 3-69). Install camshaft and cam followers (para. 3-70). Install cylinder head assemblies and pushrods (para. 3-71). Install injector assemblies (para. 3-82). Perform injection timing (para. 3-72). Install accessory drive housing assembly (para. 3-73). Install oil pump (para. 3-74). Install front gear cover (para. 3-75). Install accessory drive pulley (para. 3-76). Install air compressor (para. 3-77). Install fuel pump (para. 3-78). Install vibration damper and crankshaft pulley (para. 3-79). Install flexplate or flywheel, flywheel housing, and rear cover (para. 3-80). Install oil pan (para. 3-81). Install and adjust valve crossheads (para. 3-83). Install rocker arm housing assemblies (para. 3-84). Adjust injectors and valves (para. 3-85). Install engine retarders (para. 3-86). Install air aftercooler (para. 3-87). Remove engine from maintenance stand (para. 3-88). Install starter motor and solenoid (TM 9-2320-273-20 or TM 9-2320-283-20). Install bracket, alternator, and belts (TM 9-2320-273-20 or TM 9-2320-283-20). Install engine on vehicle (TM 9-2320-273-34 or TM 9-2320-283-34). 3-110