TM 9-2815-225-34&P CHAPTER 2 SERVICE AND TROUBLESHOOTING INSTRUCTIONS Section I. Repair Parts, Special Tools, TMDE, and Support Equipment (page 2-1) Section II. Service Upon Receipt of Equipment (page 2-1) Section III. Troubleshooting (page 2-2) Section I.  REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT NOTE All information contained in this manual applies to both M915 and M915A4/Big Cam I and M915A1 and M915A4/Big Cam III engines except where differences are specifically noted. 2-1.  OVERVIEW a. This chapter provides information on common tools, special tools, service tools, service upon receipt, and troubleshooting. b. The information is divided up into the following sections: Section I.      Repair Parts, Special Tools, Test Measurement and Diagnostic Equipment (TMDE), and Support Equipment Section II.     Service Upon Receipt Section III.   Troubleshooting 2-2.  COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE) applicable to your unit. 2-3.  SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT Special tools and support equipment are listed in Appendix B of this manual. 2-4.  REPAIR PARTS Repair parts are listed and illustrated in Appendix B of this manual. Section II.  SERVICE UPON RECEIPT OF EQUIPMENT 2-5.  ENGINE INSPECTION a. Inspect   for   any   damage   done   to   engine   during   its   removal   from   vehicle.      Refer   to   engine   removal   procedures   in TM 9-2320-273-20 and TM 9-2320-273-34 for M915/Big Cam I and TM 9-2320-283-20 and TM 9-2320-283-34 for M915A1/Big Cam III. b. Inspect,  upon  receipt  of  engine,  that  all  components  are  complete  and  that  no  engine  subassemblies  have  been  removed. Refer to information on engine dress upon removal in TM 9-2320-273-34 for M915/Big Cam I and TM 9-2320-283-34 for M915A1/Big Cam III. c. If the engine has been transferred to you from another DS/GS maintenance facility, check the equipment against the packing slip to see if the shipment is complete.  Report all discrepancies in accordance with instructions in TM 38-750. 2-1