TM 9-2815-225-34&P
3-42. OIL COOLER REPAIR (Contd)
LOCATION/ITEM
ACTION
REMARKS
d. Assembly (Contd)
32.
Adapters (59) and (53)
Install on head (46) and housing
(49).
33. Pipe plugs (39) and (40)
Install on support (41).
Tighten pipe plug (39) to
60-84 lb-in. (7-10 Nm). Tighten
pipe plug (40) to 15-25 lb-ft
(20-34 Nm).
34.
New preformed packing
Install on support (41).
Apply light coat of OE/HDO 30
(38), valve (37), two new
lubricating oil to preformed
lockwashers (36), and
packing (38). Tighten to
screws (35)
30-35 lb-ft (41-48 Nm).
35.
New gasket (52), cooler
Install on housing (49).
Tighten screws (50) to 30-35 lb-ft
core (33), gasket (34),
(41-48 Nm).
support (41), six washers
(51), new lockwashers (36),
and screws (50)
36.
Pressure sensing piston
Install on housing (49).
It will be necessary to hold in
(54), bypass valve plunger
position at same time head (46)
(55), spring (56), bypass
is installed.
valve piston (57), and
spring (58)
37.
New preformed packing (47),
Install on housing (49).
Apply light coat of OE/HDO 30
new gasket (48), head (46),
lubricating oil to preformed
three washers (51), new
packing (47). Do not tighten
lockwashers (36), and
screws (60).
screws (60)
38.
Bracket (45), three washers
Install on head (46) and housing
Tighten screws (42) and (60) to
(44), new lockwashers (43),
(49).
30-35 lb-ft (41-48 Nm).
and screws (42)
39.
Low oil pressure switch
Install.
Refer to TM 9-2320-273-20 or
TM 9-2320-283-20.
FOLLOW-ON TASK: Install oil cooler (para. 3-88).
3-234
|
|