TM 9-2815-225-34&P 3-44. OIL PUMP REPAIR (Contd) LOCATION/ITEM ACTION REMARKS d.  Assembly (Contd) NOTE Lubricate all moving parts prior to assembly with OE/HDO 10 lubricating oil. 43. Shaft (47) Press large diameter end until it Use suitable arbor press to install protrudes a minimum of 0.705 in. shaft (47).  The cover face is at the (17.907 mm) and a maximum of opposite side of gasket surface. 0.735 in. (18.669 mm) from cover face of body (29). 44. Oil pumping gear (37) Press on shaft (36) until it Use suitable arbor press to protrudes a minimum of 1.990 in. install gear (37). (50.546 mm) and a maximum of 2.010 in. (51.054 mm) from gasket surface of body (29). 45. Shaft (36), gear (37), Install as follows: woodruff key (34), and gear (54) a.  Slide shaft (36) and gear (37) through sleeve bearings (55) on body (29). b.  Insert woodruff key (34) in keyway of shaft (36). c.  Press gear (54) until shaft (36) Use shallow end of spacer protrudes a minimum of 0.050 in. mandrel (ST-1157). (1.270 mm) and has a maximum end play of 0.070 in. (1.778 mm) from gear (54). 46. Gear (46) Install on shaft (47). 47. Bypass valve spring (30), Install on body (29). Use DFC pressure valve fixture washer (31), valve disc (3376011) for installation. (32), and bypass valve seat Ensure the prongs of valve disc (33) (32) are pointing down during installation. 3-260