TM 9-2815-225-34&P 3-49.  ACCESSORY DRIVE REPAIR THIS TASK COVERS: a.  Disassembly c.  Inspection b.  Cleaning d.  Assembly INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES Puller (15434) 3376663 None TEST EQUIPMENT EQUIPMENT CONDITION None    Accessory drive pulley removed (para. 3-15).    Accessory drive housing assembly removed MATERIALS/PARTS (para. 3-18). Solvent, SD-3 (Appendix C, Item 30) Oil, lubricating, OE/HDO 10 (Appendix C, Item 20) SPECIAL ENVIRONMENTAL CONDITIONS Self-locking screw (15434) 3000173 None PERSONNEL REQUIRED GENERAL SAFETY INSTRUCTIONS Automotive repairman MOS 63H None LOCATION/ITEM ACTION REMARKS a.  Disassembly 1.   Self-locking screw (8) Remove from accessory drive Install self-locking screw (8) to and washer (9) shaft (6). prevent damage to shaft (6) when using puller (3376663). 2.   Spline coupling hub (10) Remove from accessory drive Use puller (3376663).  Remove shaft (6). and discard self-locking screw (8) after removal of spline coupling hub (10). 3.   Washer (11) and thrust Remove from accessory drive bearing (12) shaft (6). 4.   Accessory drive shaft (6) Remove from accessory drive and accessory drive gear (4) housing (15). 5.   Front dowel pin (7) Remove from accessory drive shaft (6). 6.   Accessory drive gear (4) Remove from accessory drive Use suitable arbor press.  Put and thrust bearing (5) shaft (6). housing side of gear (4) on a sup- port. 7.   Rear dowel pin (7) Remove from accessory drive shaft (6). 8.   Plug (14) Remove from accessory drive housing (15). 3-296