TM 9-2815-225-34&P 3-56.  FUEL PUMP REPAIR THIS TASK COVERS: a.  Installing Fuel Pump on Vise c.  Inspection b.  Cleaning d.  Removing Fuel Pump From Vise INITIAL SETUP: APPLICABLE MODELS TROUBLESHOOTING REFERENCES All Para. 2-8 SPECIAL TOOLS EQUIPMENT CONDITION Fuel pump mounting plate (15434) 3375133 Fuel pump removed (para. 3-16). Ball joint vise (15434) ST-302 SPECIAL ENVIRONMENTAL CONDITIONS TEST EQUIPMENT Work area clean and away from blowing dirt and None dust. MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Solvent, SD-3 (Appendix C, Item 30)    Always wear eye protection when using compressed air. PERSONNEL REQUIRED    Use approved solvent in well-ventilated area and Fuel and electrical systems repairman away from open flame. MOS 63G REFERENCES (TM) None LOCATION/ITEM ACTION REMARKS a.  Installing Fuel Pump on Vise 1. Fuel pump (2) Install fuel pump (2) on fuel pump mounting plate (3) with two screws and nuts. 2. Ball joint vise (4) Install fuel pump (2) and fuel pump Fuel pump mounting plate mounting plate (3) on ball joint (3375133) (3) may be mounted on vise (4) with two screws. ball joint vise (ST-302) (4) before installing fuel pump (2). b.  Cleaning WARNING   Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).  Use only with effective chip guarding and protective equipment such as goggles or shield, gloves, etc.  Failure to comply may result in injury to personnel.   Approved solvents may be flammable and will not be used near open flame.  Use only in well-ventilated area.  Failure to comply may result in injury to personnel. NOTE Fuel pumps used on M915/Big Cam I and M915A1/Big Cam III diesel engines are very similar but not identical.  Adjust for change accordingly. 3-384