TM 9-2815-225-34&P 3-60.  FUEL PUMP GOVERNOR SPRING REPAIR THIS TASK COVERS: a.  Removal c.  Inspection b.  Cleaning d.  Installation INITIAL SETUP: APPLICABLE MODELS TROUBLESHOOTING REFERENCES All Para. 2-8 SPECIAL TOOLS EQUIPMENT CONDITION None Fuel pump removed (para. 3-16). TEST EQUIPMENT SPECIAL ENVIRONMENTAL CONDITIONS None Work area clean and away from blowing dirt and dust. MATERIALS/PARTS Solvent, SD-3 (Appendix C, Item 30) GENERAL SAFETY INSTRUCTIONS Seal and wire (15434) 3003156    Always wear eye protection when using com- Gasket (15434) 70705 pressed air.    Use approved solvent in well-ventilated area and PERSONNEL REQUIRED away from open flame. Fuel and electrical systems repairman MOS 63G REFERENCES (TM) None LOCATION/ITEM ACTION REMARKS a.  Removal 1.   Adjusting screw seal and Remove. Discard adjusting screw seal and wire (10) wire (10). 2.   Three captive washer Remove from fuel pump (17). Discard gasket (6). screws (9), screw (12), four washers (8), spring pack cover (7), and spring pack cover-to-fuel pump gasket (6) 3.   Cover plug (11) Remove from spring pack cover (7). 4.   Snapring (13) Remove from fuel pump (17).   Discard snapring (13) if damaged during removal. 5.   High-speed spring retainer Remove from guide (4). (14), shim (15), and com- pression spring (16) 6.   Guide (4) Remove from fuel pump (17). 7.   Idle adjusting screw (5) Remove from guide (4). 8.   Idle spring plunger (1), Remove from guide (4). Lead seal (18) is used on M915/ idling spring (2), adjusting Big Cam I only. screw washer (3), and lead seal (18) 3-404