TM 9-2815-225-34&P 3-60.  FUEL PUMP GOVERNOR SPRING REPAIR (Contd) LOCATION/ITEM ACTION REMARKS b.  Cleaning WARNING   Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).  Use only with effective chip guarding and protective equipment such as goggles or shield, gloves, etc.  Failure to comply may result in injury to personnel.   Approved solvents may be flammable and will not be used near open flame.  Use only in well-ventilated area.  Failure to comply may result in injury to personnel. 9.   All parts Clean with SD-3 solvent and Refer to para. 3-6 for dry with compressed air. additional cleaning instructions. c.  Inspection 10.     All parts Inspect for cracks, breaks, Discard any damaged parts. and other damage. 11.     All threaded parts Inspect for crossthreading, Discard any damaged parts. stripped threads, and other damage. d.  Installation 12.     Idle adjusting screw (5) Install on guide (4). 13.     Adjusting screw washer (3) Place over idle adjusting screw (5) in guide (4). 14.     Idling spring (2) Slide in guide (4) and over idle adjusting screw (5). 15.     Idle spring plunger (1) Place in guide (4) against idling spring (2). 16.     Compression spring (16), Slide on guide (4). Final number of shims (15), shim (15), and high-speed is determined at calibration. spring retainer (14) 17.     Guide (4) and attached a.  Place in fuel pump (17). parts b.  Secure with snapring (13). 18.     Idle adjusting screw (5) Turn clockwise by hand until Final adjustment is made at contact is made with seat. calibration. 19.     Cover plug (11) Install on spring pack cover (7). 20.     Cover (7) and new spring a.  Install on fuel pump (17). pack cover-to-fuel pump gasket (6) b.  Secure with three captive Put screw with lockwire hole in washer screws (9), screw (12), and lower right corner.  Torque all four washers (8). screws to 9-11 lb-ft (12-15 Nm). 3-406