Custom Search
 
  
 
TM 9-2815-225-34&P 3-62.  FUEL PUMP MAIN HOUSING REPAIR (Contd) LOCATION/ITEM ACTION REMARKS d.  Assembly (Contd) 44. Throttle plunger (13) (with Install on barrel (20). Insert very carefully to avoid attached parts) damage to plunger (13). 45. Bellows (9) a.  Carefully push down between Ensure bellows (9) is flat where it AFC piston (10) and housing (38). touches housing (38). b.  Line up holes in bellows (9) Ensure bellows (9) is flat where with holes in housing (38). it touches housing (38). 46. Fuel control cover (4) a.  Install on bellows (9) and housing (38). b.  Secure with two screws (1), Do not tighten screws (1).  This drilled-head screw (2), and will be done after AFC is set on three washers (3). test stand. 47. Check valve (58) a.  Ensure check ball is loose and hole near bottom of valve (58) is not plugged. b.  Turn on top of fuel control Tighten to 5 lb-ft (7 Nm). cover (4). 48. Fuel filter screen (25), Install on housing (38). Ensure hole in fuel filter spring (26), new cap seal screen (25) faces down.  Tighten ring (27), and filter screen filter screen cap (28) to 8-12 lb-ft cap (28) (11-16 Nm). 49. Tapered stud (54) Install on housing (38). 50. Jamnut (12) Install on tapered stud (54). 51. Threaded stud (32) and a.  Assemble together. jamnut (12) b.  Install on housing (38). 52. AFC needle valve (29) and a.  Lubricate O-ring (30) and new O-ring (30) install on AFC needle valve (29). b.  Install on housing (38) until AFC needle valve (29) bottoms out. 53. Throttle shaft (50) a.  Install on stop (47). b.  Secure with setscrew (46).   Do not tighten at this time. 54. Fuel adjusting screw (49) a.  Lubricate O-ring (48) and and new O-ring (48) install on fuel adjusting screw (49). b.  Insert fuel adjusting screw (49) Ensure fuel hole in throttle shaft in throttle shaft (50) about six (50) is open. rotations. 55. Throttle shaft (50) and new a.  Lubricate O-ring (51) and O-ring (51) install on throttle shaft (50). b.  Insert throttle shaft (50) into Setscrew (46) in stop (47) faces housing (38) with counterbore upward. of fuel port facing down. c.  Tighten setscrew (46) to 7-9 lb-ft (9-12 Nm). 3-444


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business