TM 9-2815-225-34&P 3-13. MOUNTING ENGINE ON MAINTENANCE STAND (Contd) LOCATION/ITEM ACTION REMARKS e.  Component Removal (Contd) 52. Modulator bracket and Remove. Refer to TM 9-2320-273-20 or accelerator return spring TM 9-2320-283-20. 53. Ether quick-start cylinder, Remove. Refer to TM 9-2320-273-20 or valve, and thermostat TM 9-2320-283-20. 54. Engine wiring harness Tag for identification at Refer to TM 9-2320-273-20 or connections reassembly, then disconnect. TM 9-2320-283-20. 55. Engine wiring harness Remove. Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 56. Fan, fan clutch, and fan Remove. Refer to TM 9-2320-273-20 or clutch drive belts TM 9-2320-283-20. 57. Fan brace, bracket, and Remove. Refer to TM 9-2320-273-20 or spacers TM 9-2320-283-20. 58. Water pump and drive belts Remove. Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 59. Power steering pump and Remove. Refer to TM 9-2320-273-20 or reservoir TM 9-2320-283-20. NOTE Perform steps 60 and 61 for M915/Big Cam I only. Perform steps 62 and 63 for M915A1/Big Cam III only. 60. Four clamps (65), two Remove from flange (84). water transfer hoses (64), and water transfer tube (86) 61. Six screws (83), flange (84), Remove from cylinder block (12). Discard gasket (85). and gasket (85) 62. Twelve captive washer Remove from cylinder block (12). Discard gaskets (87). screws (89), two water header covers (88), and gaskets (87) 63. Six self-locking screws (92), Remove from cylinder block (12). Discard preformed packings (90). nozzles (91), and preformed packings (90) 3-22