TM 9-2815-225-34&P 3-67.  CYLINDER LINER INSTALLATION THIS TASK COVERS: Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES None Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None Cylinder liners removed (para. 3-30). MATERIALS/PARTS SPECIAL ENVIRONMENTAL CONDITIONS Oil, lubricating, OE/HDO 30 Work area clean and away from blowing dirt and (Appendix C, Item 21) dust. Oil, lubricating, gear 60-80/140 (Appendix C, Item 22) GENERAL SAFETY INSTRUCTIONS None PERSONNEL REQUIRED Automotive repairman MOS 63H LOCATION/ITEM ACTION REMARKS Installation NOTE   Installation of cylinder liners is carried out during cylinder block repair.  This is necessary to   check   cylinder   liner   counterbore   diameter,   depth,   protrusion,   sealant   application procedure, and type of packing ring lubricant used.   Refer to para. 3-34, Cylinder Block Repair, for complete installation procedure of cylinder liners. FOLLOW-ON TASK:   Install engine crankshaft and main bearings (para. 3-68). 3-542