TM 9-2815-225-34&P 3-68.  ENGINE CRANKSHAFT AND MAIN BEARINGS INSTALLATION (Contd) LOCATION/ITEM ACTION REMARKS Installation (Contd) CAUTION When  striking  bearing  caps,  ensure  bearing  halves  and  retaining  rings  do  not  move  or damage may result. 10. No. 7 bearing cap (7) and Strike with rubber mallet to Ensure dowel pins and thrust No. 1 through No. 6 push into position on cylinder bearing washers (5) for No. 7 bearing caps (8) block (1). bearing cap (7) are correctly aligned. 11. Fourteen screws (10) a.  Tighten each screw (10) to 85 lb-ft (115 Nm) at a time in sequence shown until each screw is tightened to 250-260 lb-ft (339-353 Nm). b.  Loosen fourteen screws (10) three to five threads or a minimum of three complete turns. c.  Repeat step 11a. 3-548