Custom Search
 
  
 
TM 9-2815-225-34&P 3-15. ACCESSORY DRIVE PULLEY REMOVAL THIS TASK COVERS: Removal INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES None Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None Vibration damper and crankshaft pulley removed (para. 3-14). MATERIALS/PARTS SPECIAL ENVIRONMENTAL CONDITION Locknut (15434) 3012526 Work area clean and away from blowing dust and dirt. PERSONNEL REQUIRED Automotive repairman MOS 63H GENERAL SAFETY INSTRUCTIONS None LOCATION/ITEM ACTION REMARKS Removal NOTE Perform step 1 for M915A1/Big Cam III engines only. 1. Six screws (1) and accessory Remove from accessory drive Do not let accessory drive drive pulley (4) pulley assembly (6). pulley (4) rotate when removing screws (1).  Hold onto accessory drive pulley (4) when removing last screw (1). CAUTION Do not use jaw-type puller.  Damage to pulley will result. When installing puller, ensure screws do not bottom out on front gear cover.  Damage to cover may result. 2. Locknut (2) and washer (3) Remove from accessory driveshaft Discard locknut (2). (7). 3. Accessory drive pulley Using suitable puller, remove Use caution not to damage assembly (6) (M915A1/ Big from accessory drive shaft (7). accessory drive shaft (7).  Do not Cam III), accessory drive use jaw-type puller; use puller pulley (4) (M915/Big Cam I), as explained in above caution. keyway seal (5), and sleeve (8) FOLLOW-ON TASKS: For repair of accessory drive pulley (para. 3-49). For installation of accessory drive pulley (para. 3-76). 3-28


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business