TM 9-2815-225-34&P 3-71.  CYLINDER HEAD ASSEMBLY AND PUSHRODS INSTALLATION THIS TASK COVERS: Installation INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES None Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None Pistons, connecting rods, and bearings installed (para. 3-69). MATERIALS/PARTS Lubricant, rust preventative SPECIAL ENVIRONMENTAL CONDITIONS (Appendix C, Item 16) Work area clean and away from blowing dirt and Oil, lubricating, gear GO-80/140 dust. (Appendix C, Item 22) Cylinder head gasket (15434) 3047402 GENERAL SAFETY INSTRUCTIONS Four preformed packings (15434) 131026 None PERSONNEL REQUIRED Automotive repairman MOS 63H LOCATION/ITEM ACTION REMARKS Installation NOTE   The following procedure involves installation of one cylinder head assembly.  Installation of remaining cylinder heads is similar.  Repeat steps 1 through 9 to install each additional cylinder head assembly as required.   Ensure   marks   made   on   each   cylinder   head   and   cylinder   block   during   removal   are matched together during installation so that each cylinder head assembly is installed in its original position on cylinder block. 1. New cylinder head Install on dowel pins of cylinder Ensure new cylinder head gasket (8) block (7). gasket (8) has the side with word TOP facing upwards. 2. Cylinder head assembly (6) Install on cylinder block (7). Assistant will help lift cylinder head assembly (6).  Use T-handles to assist in positioning cylinder head assembly (6). CAUTION Cylinder head screws on turbocharged engines are made of hardened material.  The letters NT  are  stamped  on  the  head  of  these  screws.    Do  not  use  any  other  screws  to  secure cylinder heads.  Engine damage may result. 3-562