TM 9-2815-225-34&P 3-80. FLEXPLATE OR FLYWHEEL, FLYWHEEL HOUSING, AND REAR COVER INSTALLATION (Contd) LOCATION/ITEM ACTION REMARKS Installation (Contd) NOTE The   flywheel   must   be   pushed   toward   front   of   engine   to   remove   crankshaft   end clearance when crankshaft is rotated and measurements are taken. If total indicator readings exceed limits listed in steps 8 and 9, remove flywheel; clean flywheel and crankshaft flange faces, install, and repeat runout checks. 8. Inspect flywheel (22) bore a.  Install dial gauge attachment Use dial gauge attachment runout (M915/Big Cam I) (14) and dial indicator and sleeve (ST-1325) and dial indicator assembly (13) on flywheel and sleeve assembly (3376050). housing (6).  Position contact tip of dial indicator against wide diameter of flywheel bore and set dial indicator to zero. b.  Use accessory drive shaft Total indicator reading must to rotate crankshaft one not exceed 0.005 in.  (0.127 mm). complete revolution. 9. Inspect flywheel (22) face a.  Install or reposition dial Use dial indicator and sleeve runout (M915/Big Cam I) indicator and sleeve assembly (13) assembly (3376050). on flywheel housing (6). Position contact tip of dial indicator against face of flywheel (22) as close to outside diameter as possible. b.  Use accessory drive shaft Total indicator reading must to rotate crankshaft one not exceed 0.005 in.  (0.127 mm). complete revolution. FOLLOW-ON TASK: Install oil pan (para. 3-81). 3-618