TM 9-2815-225-34&P
3-88. REMOVING ENGINE FROM MAINTENANCE STAND (Contd)
LOCATION/ITEM
ACTION
REMARKS
b. Component Installation (Contd)
14. Modulator bracket and
Install.
Refer to TM 9-2320-273-20 or
accelerator return spring
TM 9-2320-283-20.
15. Air compressor governor
Install.
Refer to TM 9-2320-273-20 or
and air lines
TM 9-2320-283-20.
16. Air compressor intake tube
Install.
Refer to TM 9-2320-273-20 or
TM 9-2320-283-20.
17. Air compressor discharge
Install.
Refer to TM 9-2320-273-20 or
hose
TM 9-2320-283-20.
18. Water bypass tube
Install.
Refer to TM 9-2320-273-20 or
TM 9-2320-283-20.
19. Water pump-to-radiator
Install.
Refer to TM 9-2320-273-20 or
connection
TM 9-2320-283-20.
20. Water pump bypass hose
Install.
Refer to TM 9-2320-273-20 or
TM 9-2320-283-20.
NOTE
Perform steps 21 through 23 for M915/Big Cam I only.
Perform steps 24 and 25 for M915A1/Big Cam III only.
21. Gasket (23), oil cooler
Install on water transfer hose (11),
Tighten screws (25), (22), and (26)
assembly (27), five new
cylinder block (6), and oil cooler
to 30-35 lb-ft (41-48 Nm).
lockwashers (20), two screws
support (24).
(25), two screws (22), and
screw (26)
22. Clamp (10)
Tighten at water transfer hose (11).
23. New lockwasher (20) and
Install on support bracket (21)
Tighten screw (19) to 30-35 lb-ft
screw (19)
and cylinder block (6).
(41-48 Nm).
24. Gasket (32), oil cooler
Install on oil cooler support (33)
Tighten screws (36) and (34) to
assembly (37), six new
and cylinder block (6).
30-35 lb-ft (41-48 Nm).
lockwashers (35), three
screws (36), and screws (34)
25. Two washers (30), new
Install on support bracket (31)
Tighten screws (28) to 30-35 lb-ft
lockwashers (29), and
and cylinder block (6).
(41-48 Nm).
screws (28)
3-664
|
|