TM 9-2815-225-34&P 3-88.  REMOVING ENGINE FROM MAINTENANCE STAND (Contd) LOCATION/ITEM ACTION REMARKS b.  Component Installation (Contd) 40.    Water filter and bracket Install.   Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 41.    Water shutoff valves and Install. Refer to TM 9-2320-273-20 or hoses TM 9-2320-283-20. 42.    New gasket (57) Install on studs (56). Install gasket (57) with bead fac- ing turbocharger (50).  Coat threads of studs (56) with anti- seize compound. 43.    Turbocharger (50) and Install on studs (56) and exhaust Tighten nuts (58) to 20-25 lb-ft four nuts (58) manifold (46). (27-34 Nm). NOTE   Perform step 44 for M915/Big Cam I only.   Perform steps 45 and 46 for M915A1/Big Cam III only. 44.    Hose (66), two clamps (65), Install on elbows (67) and (62). Tighten clamps (65) to 35-45 lb-ft and oil return tube (64) (48-61 Nm). 45.    Hose (66), two clamps (65), Install on elbows (67) and (59). Tighten clamps (65) to 35-45 lb-ft and oil return tube (63) (48-61 Nm). 46.    Two bushings (61) and oil Install on filter head (68) and oil Tighten fittings on oil return tube return tube (60) return tube (63). (60) to 50-60 lb-ft (68-81 Nm). 47.    Oil supply hose (51) Install on adapter (54) and elbow Tighten fittings on oil supply (55). hose (51) to 50-60 lb-ft (68-81 Nm). 48.    Clamp (52) and screw (53) Install on oil supply hose (51) Tighten screw (53) to 14 lb-ft and turbocharger (50). (19 Nm). 49.    Turbocharger air Install. Refer to TM 9-2320-273-20 or crossover connection TM 9-2320-283-20. 50.    Oil breather tubes and Install. Refer to TM 9-2320-273-20 or hoses TM 9-2320-283-20. 3-668