TM 9-2815-225-34&P 3-88.  REMOVING ENGINE FROM MAINTENANCE STAND (Contd) LOCATION/ITEM ACTION REMARKS b.  Component Installation (Contd) 51.     New gasket (83), oil level Install on cylinder block (6). Tighten captive washer screws dipstick tube and cover (76), (81) to 30-35 lb-ft (41-48 Nm). four washers (82), and captive washer screws (81) 52.     Tube brace (72), clamp (80), Install on oil level dipstick tube two washers (79), screw (84), and cover (76). new lockwasher (78), and nut (77) 53.     Washer (73), new lockwasher Install on tube brace (72) and (74), and screw (75) cylinder block (6). 54.     Oil level dipstick Install.   Refer to TM 9-2320-273-20 or TM 9-2320-283-20. 55.     Heater control valve, Install. Refer to TM 9-2320-273-20 or shutoff valve, and supply TM 9-2320-283-20. tube 56.     Heater return tube Install.   Refer to TM 9-2320-273-20 or TM 9-2320-283-20. NOTE Perform step 57 for M915/Big Cam I only. 57.     Transmission control-body Install on cylinder block (6). heating elements ON/OFF switch (69) 58.     Oil pressure gauge sending Install on cylinder block (6). unit (70) and low oil pressure warning light sending unit (71) 59.     Engine wiring harness leads Connect.   Refer to TM 9-2320-273-20 or TM 9-2320-283-20. FOLLOW-ON TASKS: Install starter motor and solenoid (TM 9-2320-273-20 or TM 9-2320-283-20). Install alternator, belts, and bracket (TM 9-2320-273-20 or TM 9-2320-283-20). Start repaired engine (para. 3-91). Install STE/ICE harness, receptacle, and bracket (TM 9-2320-273-20 or TM 9-2320-283-20). 3-670