TM 9-2815-225-34&P 3-93.  ON-ENGINE FUEL PUMP ADJUSTMENT (Contd) LOCATION/ITEM ACTION REMARKS j.  Fuel Pump Seal Installation NOTE Fuel pump must be sealed after final adjustments are made to prevent tampering. 28.     Spring pack cover (9), a.  Using lockwire and seal (34), Seals spring pack cover (9) and screw (8), threaded stud insert lockwire through screw (8), threaded stud (27). (27), and plug (7) plug (7), and threaded stud (27). b.  Twist lockwires together until connection is secure and lockwire is tight. c.  Bend twisted lockwire into seal and press on top half of seal. 29.     Spring pack cover (9), a.  Using lockwire and seal (34), Seals cover assembly (32). screw (8), cover assembly insert lockwire through screw (8), (32), captive washer screw drilled fillister head screw (35), (33), and drilled fllister and captive washer screw (33). head screw (35) b.  Twist lockwires together until connection is secure and lockwire is tight. c.  Bend twisted lockwire into seal and press on top half of seal. k.  Throttle Shaft Cover Plate Installation 30.     Throttle shaft cover a.  Position new throttle Use No. 44 0.086 in. (2.184 mm) plate (36) and two drive shaft cover plate (36) on drill.  Use etching tool or steel screws (37) housing (38). stamp and imprint date of repair on backside of throttle shaft cover plate (36) for future reference. b.  Drill two new holes on opposite sides of throttle shaft cover plate (36) 0.235 in. (5.969 mm) into pump housing.  Do not attempt to drill out and reuse old mounting holes. c.  Secure new throttle shaft cover plate (36) with two drive screws (37). FOLLOW-ON TASK:  Install engine in vehicle if tests done on engine dynamometer (TM 9-2320-273-34). 3-702