TM 9-2815-225-34&P 3-23.  INJECTOR ASSEMBLY REMOVAL THIS TASK COVERS: Removal INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES Injector puller (15434) 3376872 Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None Rocker arm housing assembly and pushrods removed (para. 3-22). MATERIALS/PARTS None SPECIAL ENVIRONMENTAL CONDITIONS Work area clean and away from blowing dust and PERSONNEL REQUIRED dirt. Automotive repairman MOS 63H GENERAL SAFETY INSTRUCTIONS None LOCATION/ITEM ACTION REMARKS Removal CAUTION Ensure injectors, injector links, and plungers are not intermixed.  Keep all injector parts with individual injectors.  After removal, put injectors in suitable rack to ensure proper order of installation and protect them from damage and dirt. NOTE The  following  procedure  covers  removal  of  one  fuel  injector.    Removal  of  remaining  fuel injectors is similar. 1. Two screws (5) and retaining Remove from cylinder head plate (2) (M915/Big Cam I) assembly (4) and injector or clamp (2) (M915A1/Big assembly (3). Cam III) 2. Detent plunger (1) Remove from injector assembly (3). 3. Injector assembly (3) Remove from cylinder head Use injector puller (3376872) for assembly (4). removal.  After removal, place detent plunger (1) in injector assembly (3) and wrap injector assembly (3) in clean cloth. FOLLOW-ON TASKS: For repair of fuel injector (para. 3-52). For installation of injector assembly (para. 3-82). 3-52