TM 9-2815-225-34&P
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS
Figure D-1. Oil Level Dipstick.
INSTRUCTIONS:
1.
Fabricate from NSN 6680-01-108-7410.
2.
Measure 39.13 in. (994 mm) down dipstick from bottom of rubber stopper and cut dipstick. Round off tip of dipstick as shown
above.
NOTE
Use an electric engraver to perform etching in steps 3, 4, and 5. Etch dipstick to a depth of
0.005 to 0.010 in. (0.127 to 0.254 mm).
3.
Measure 36.31 in. (992 mm) down dipstick from bottom of rubber stopper and etch a line on dipstick at this length. Etch an
"H" next to this line as shown above.
4.
Measure 2.06 in. (52 mm) down dipstick from line etched in step 3 and etch another line at this length. Etch an "L" next to this
line as shown above.
5.
Etch part number "199453" on dipstick near rubber stopper as shown above.
D-2
|
|
