TM 9-2815-225-34&P
Section I. STANDARD TORQUE SPECIFICATIONS
1.
Always use the torque values listed on previous page when specifications are not available.
NOTE
Do not use listed values in place of those specified in this manual; special attention should
be observed in case of SAE Grade 6, 7, and 8 screw.
2.
Torques are based on use of clean and dry threads.
3.
Reduce torque by 10 percent when oil is used as a lubricant.
4.
Reduce torque by 20 percent if newly plated screws are used.
CAUTION
Screws threaded into aluminum may require reductions in torque of 30 percent or more
unless inserts are used.
E-2
|
|
