TM 9-2815-225-34&P 3-27. FRONT GEAR COVER REMOVAL THIS TASK COVERS: Removal INITIAL SETUP: APPLICABLE MODELS REFERENCES (TM) All None SPECIAL TOOLS TROUBLESHOOTING REFERENCES None Para. 2-8 TEST EQUIPMENT EQUIPMENT CONDITION None    Oil pan removed (para. 3-26).    Vibration damper and crankshaft pulley removed MATERIALS/PARTS (para. 3-14). Gasket (15434) 3021704    Accessory drive pulley removed (para. 3-15). Preformed packing (15434) 215705    Accessory drive housing removed (para. 3-18). Lockwasher (96906) MS35338-47    Oil pump removed (para. 3-19). (M915/Big Cam I) Three lockwashers (15434) S604 SPECIAL ENVIRONMENTAL CONDITIONS (M915/Big Cam I) Work area clean and away from blowing dirt and dust. PERSONNEL REQUIRED Automotive repairman MOS 63H GENERAL SAFETY INSTRUCTIONS None LOCATION/ITEM ACTION REMARKS Removal 1. Six screws (1), washers (2), Remove from cylinder block (13) Hold front engine support (3) two screws (16) (M915/Big and gear cover (11). during removal of last screw (16). Cam I) or two captive washer screws (16) (M915A1/Big Cam III only), two washers (17) (M915/Big Cam I only), and front engine support (3) NOTE Perform step 2 for M915/Big Cam I only. Perform step 3 for M915A1/Big Cam III only. 2. Three screws (4), Remove from gear cover (11). Use a soft-nose hammer and lockwashers (18), gently tap camshaft support (5) washers (19), camshaft loose, if necessary.  Discard support (5), shim pack (6) lockwashers (18) and packing (7). and preformed packing (7) 3. Three captive washer Remove from gear cover (11). Use a soft-nose hammer and screws (4), camshaft gently tap camshaft support (5) to support (5), shim pack (6), loosen, if necessary.  Discard and preformed packing (7) packing (7). 4. Two screws (8) (M915/Big Remove from cylinder block (13) Discard lockwasher (9). Cam I only) or two captive and gear cover (11). washer screws (8) (M915A1/ Big Cam III only), lockwasher (9) and washer (10) (M915/ Big Cam I only), nine captive washer screws (15), and captive washer screw (14) 3-64