| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
(d) Screw driver into end of shaft assembly.
(e) Insert driver end of tool into camshaft bearing.
(f) Using slide hammer, tap bearing out of bore.
NOTE
An extension to shaft assembly is available to provide extended reach into block.
(g) Drive remaining bearings out of bore in same manner.
(h) Measure inside diameter of each bearing bore in block.
Discard block if any diameter exceeds
2.6265 in. (66.7131 mm).
3-56
|
||
|
||
