| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
(f) Back off thimble on micrometer to retract spindle and recheck cutter assembly length. Length must
be set for 6.750 in. (171.450 mm) micrometer reading.
(g) Rotate cutter plate until plate tool bit recess is at large ope ning in base plate.
(h) Insert cutter assembly all the way into cutter plate. While holding tip of tool bit, tighten setscrew with
hex key wrench.
(i) Place a 0.004 in. (0.101 mm) feeler gage between cylinder block and tool bit and lower cutter plate
until tool rests on feeler gage.
3-80
|
||
|
||
