| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
(2) Preset and install cutter assembly.
(a) Loosen adjusting pin setscrew at rear of cutter assembly and push cutter adjusting pin all the way in.
Tighten setscrew.
(b) Adjust micrometer on ST-1168-74 micrometer block assembly to 6.750 in. (171.450 mm).
(c) Place tool bit end of cutter assembly against pad on micrometer block assembly.
(d) While holding cutter assembly against pad, loosen adjusting pin setscrew on cutter assembly.
Internal spring will push adjusting pin against micrometer spindle.
(e) Tighten adjusting pin setscrew.
3-79
|
||
|
||
