| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-1
Section XV. VIBRATION DAMPER REPAIR
3-42. INSPECT VIBRATION DAMPER AND PULLEY
a. Separate damper from pulley.
b. Clean damper and pulley.
WARNING
WEAR PROTECTIVE CLOTHING AND GOGGLES WHILE STEAM CLEANING TO
PREVENT PERSONAL INJURY.
P-D-680 SOLVENT IS POTENTIALLY DANGEROUS. AVOID PROLONGED OR
REPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVE
HEAT.
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30 PSI
(207 KPA). USE ONLY WITH EFFECTIVE CHIP GUARDING AND PERSONAL
PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC).
(1) Steam clean both components and dry thoroughly with compressed air.
(2) Remove stubborn dirt, tar, and grease with solvent.
c. Inspect damper.
CAUTION
DO NOT USE COARSE EMERY
CLOTH OR SCRAPER TO REMOVE
PAINT.
EXCESS
MATERIAL
REMOVAL MAY RESULT IN FALSE
MEASUREMENTS.
NOTE
Damper is not repairable. If inspection
shows defects, replace damper.
3-224
|
||
|
||
