| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
h. Slide tool no. 3375180 oil seal pilot onto impeller end of shaft.
i. Apply thin coat of sealant to outer races of bearings (5 and 8).
j. With ST-658 bearing mandrel, insert bearings and shaft assembly into water pump housing bore and press into
housing until seated.
k. Remove oil seal pilot from impeller end of shaft.
l. Install large retaining ring (4) (with beveled side up) inside housing groove against bearing.
m. Remove pipe plug (11) from pump housing (18) and install grease fitting.
CAUTION
DO NOT OVERFILL CAVITY.
BEARING OVERHEATING AND FAILURE MAY
RESULT.
n. Pump grease MIL-G-3545 into cavity until it first appears at outer bearing.
o. Using ST-1191 seal driver, press front grease seal (3), with seal lip toward bearing into pump housing (18) until
flush with face of bore.
p. Turn housing over.
3-396
|
||
|
||
