TM 9-2815-237-34 2-45.  REPAIR  AND  REPLACEMENT  STANDARDS  (Cont’d) Table 2-3. General Repair Standards (6.5L) (Cont’d). Piston  Pin Diameter Clearance Fit  in  Rod Camshaft Lift: Intake Exhaust Journal  Diameter  -  #  1,2,3,4 Journal Diameter – # 5 Journal  Clearance Crankshaft Main Journal Diameter - # 1,2, 3,4 Main Journal Diameter – # 5 Taper Out  of  Round Main Bearing Clearance – # 1,2,3,4,5 End Play Crankpin: Diameter Taper Out  of  Round Rod Bearing Clearance Rod Side Clearance Valve Train Rocker Arm Ratio Face  Angle Seat  Angle Seat Runout Seat  Width: Intake Exhaust Stem   Clearance: Intake Exhaust Valve Spring Force Closed Open Installed  Height Timing Chain Deflection New Chain Old Chain STANDARD 1.2203-1.2206  in. 0.0003-0.0006  in. 0.0003-0.0010  in. 0.281±0.002  in. 0.281±.002  in. 2.164-2.166  in. 2.007-2.009  in. 0.001-0.004  in. 2,949-2.950  in. 2.949-2.950  in. 0.0002  in.  max. 0.0002  in.  max. 0.002-0.004  in. 0.004-0.010  in. 2.398-2.399  in. 0.0002  in.  max. 0.0002  in.  max. 0.002-0.004  in. 0.007-0.025  in. 1.5:1 45° 46° 0.002  in. 0.035-0.060  in. 0.062-0.093  in. 0.001-0.003  in. 0.001-0.003  in. 80 lb @ 1.8 in. 230 lb@ 1.39 in. 1.8  in. 0.5 in. max. 0.81 in. max. METRIC 30.9956-31.0032 mm 0.0076-0.0153   mm 0.0076-0.025  mm 7.137±0.05  mm 7.137±0.05  mm 54.965-55.016 mm 50.978-51.029 mm 0.025-0.102  mm 74.905-74.930 mm 74.905-74.930   mm 0.0051  mm  max. 0.0051  mm  max. 0.051-0.102  mm 0.102-0.254  mm 60.909-60.935 mm 0.0051  mm  max. 0.0051  mm  max. 0.051-0.102  mm 0.178-0.635  mm 1.5:1 45° 46° 0.05  mm 0.89-1.52  mm 1.57-2.36  mm 0.025-0.076  mm 0.025-0.076  mm 356 N @ 46.0 mm 1023 N @ 35.3 mm 46.0  mm 12.7 mm max. 20.6  mm  max. 2-192