TM 9-2815-237-34 2-8 Change 1 2-14.   MOUNTING ENGINE ON REPAIR STAND This task covers: a. Installation b. Removal General Safety Instructions Direct personnel to stand clear during hoisting operation. a.  Installation NOTE Do not perform step 1 if engine lifting sling has been previously installed. 1. Position engine lifting sling on engine (4) and secure to right cylinder head (10) with two bolts (11). Finger tighten bolts (11). 2. Install sling bracket (2) to engine lifting sling with pin (3) and on left cylinder head (1) with two bolts (9). Tighten bolts (9) and (11). WARNING Direct personnel to stand clear during hoisting operation. Failure to do this may cause injury to personnel. 3. Attach hoist to engine lifting sling and hoist engine (4) into position over engine repair stand. 4. Loosen four capscrews (5) securing repair stand arms (6) on engine repair stand and align arms (6) with holes in rear of engine (4). 5. Install repair stand arms (6) to engine (4) with four washers (8) and capscrews (7). 6. Tighten capscrews (5) and (7). 7. Disconnect hoist and remove two bolts (11) and (9), engine lifting sling, and bracket (2) from engine (4). b.  Removal 1. Position engine lifting sling on engine (4) and secure to right cylinder head (10) with two bolts (11). Finger tighten bolts (11). 2. Install sling bracket (2) to engine lifting sling with pin (3) and on left cylinder head (1) with two bolts (9). Tighten bolts (9) and (11). 3. Attach hoist to engine lifting sling and hoist engine (4) to relieve pressure on engine repair stand. 4. Remove four capscrews (7) and washers (8) from repair stand arms (6) and hoist engine away from engine repair stand. INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix E, Item 1) Special Tools Engine repair stand (Appendix E, Item 2) Engine lifting sling (Appendix E, Item 3)