TM 9--2815--247--34 0036 00--1 FUEL INJECTOR NOZZLE AND HOLDER REPAIR 0036 00 THIS WORK PACKAGE COVERS: Removal, Test, Disassembly, Clearning, Inspection, Repair, Assembly, Installation INITIAL SETUP: Tools General mechanic’s tool kit (item 19, WP 0103 00) Mechanical puller (item 30, WP 0103 00) Open--end wrench (item 56, WP 0103 00) Tube assembly (item 53, WP 0103 00) Socket wrench socket (item 45, WP 0103 00) Torque wrench (item 51, WP 0103 00) Nozzle carbon cutter (item 12, WP 0103 00) Fuel injector tester (item 85, WP 0103 00) Machinist Vise (item 83, WP 0103 00) Materials/Parts Preformed packing (item 68, WP 0102 00) Preformed packing (item 62, WP 0102 00) Flat washer (item 140, WP 0102 00) Preformed packing (item 73, WP 0102 00) Materials/Parts -- Continued Carbon removing compound (item 3, WP 0100 00) Anti--seize compound (item 1, WP 0100 00) Equipment Conditions Engine level on flat surface (WP 0021 00) Engine cleaned (TM 9--2350--292--20) Fuel injector tubes, brackets and associated parts removed (WP 0037 00) Injector fuel return hoses removed (TM 9--2350--292--20) References TM 9--2350--292--20 NOTE Procedure is the same for each of 12 fuel injector nozzle and holder assemblies. If all the fuel injector nozzle and holder assemblies are not to be removed, it is not neces- sary to remove all the fuel injector tubes and injector fuel return lines. Removal 1.   Using wrench (1) on the retainer (2), loosen and remove fuel injector nozzle and holder assembly (3). Figure 34 1 2 3