TM 9--2815--247--34
0037 00--16
FUEL INJECTOR TUBES, BRACKETS, AND ASSOCIATED PARTS --
CONTINUED
0037 00
Installation -- Continued
35. Install floating clamp (DETAIL E) in location shown in illustration.
CAUTION
Where bending tubes is required, be careful not to nick
tubing. The bending tools are designed to allow bending
without nicks.
36. Using two bending tools (72), align tubes to fit within 1/8 inch (3.175 mm) in any direction with fairlead halves.
37. Apply a small amount of lubricant (item 12, WP 0100 00) to threads of screw (22).
38. Install two fairlead halves (25), two retaining straps (24), screw (22), and new self--locking nut (23) (DETAIL E).
39. Tighten screw (22) to 160--180 lb--in (18--20 NSm).
Figure 36
E
22
24
25
25
24
23
RIGHT BANK
LEFT BANK
FLYWHEEL
END
DAMPER
END
E
72
72
|
|
