TM 9--2815--247--34 0037 00--15 FUEL INJECTOR TUBES, BRACKETS, AND ASSOCIATED PARTS -- CONTINUED 0037 00 Installation -- Continued 30. Install floating clamps (DETAIL D) in location shown in illustration. CAUTION Where bending tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. 31. Using two bending tools (72), align tubes to fit within 1/8 inch (3.175 mm) in any direction with fairlead halves. 32. Apply a small amount of lubricant (item 12, WP 0100 00) to threads of six bolts (18). 33. Install 12 fairlead halves (21), 12 retaining straps (20), six bolts (18), and six new self--locking nuts (19) (DETAIL D). 34. Tighten six bolts (18) to 160--180 lb--in (18--20 NSm). Figure 36 D 18 19 20 21 20 21 RIGHT BANK LEFT BANK FLYWHEEL END DAMPER END D D D D 72 72