TM 9--2815--247--34 0048 00--1 THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS REPAIR 0048 00 THIS WORK PACKAGE COVERS: Test, Removal, Disassembly, Inspection, Repair, Assembly, Installation, Adjust INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Mechanical gear puller kit (item 18, WP 0103 00) Snap ring pliers (item 44, WP 0103 00) Outside micrometer caliper set (item 9, WP 0103 00) Telescoping gauge set (item 16, WP 0103 00) Torque wrench (item 50, WP 0103 00) Spring tester (item 47, WP 0103 00) Reamer (item 32, WP 0103 00) Safety goggles (item 28, WP 0103 00) Materials/Parts Self--locking nut (item 49, WP 0102 00) Cotter pin (item 91, WP 0102 00) Lockwashers (5) (item 147, WP 0102 00) Gasket (item 23, WP 0102 00) Retaining rings (7) item 111, WP 0102 00) Plain encased seal (item 132, WP 0102 00) Plain encased seal (item 133, WP 0102 00) Materials/Parts -- Continued Gasket (item 22, WP 0102 00) Woodruff keys (2) (item 40, WP 0102 00) Lockwashers (4) (item 146, WP 0102 00) Retaining rings (2) (item 122, WP 0102 00) Retaining rings (2) (item 113, WP 0102 00) Equipment Conditions Engine level on flat surface (WP 0021 00) Engine cleaned and drained (TM 9--2350--292--20) Wiring harness 3W202 removed from throttle control solenoid (TM 9--2350--292--20) Oil cooler breather tubes removed (TM 9--2350--292--20) References TM 9--2350--292--20 Test 1.   Disconnect rigid connecting link (1) by removing cotter pin (2) and flat washer (3). Discard cotter pin. 2.   Disconnect control rod assembly (4) by removing self--locking nut (5) and machine bolt (6). Discard self--locking nut. Figure 48 2 3 6 4 5 1