TM 9--2815--247--34 0048 00--10 THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0048 00 Inspection -- Continued 11. Visually inspect throttle lever housing (78) and pin (79). Refer to WP 0012 00. 12. Visually inspect solenoid housing assembly (80) and pins (81 and 82). Refer to WP 0012 00. 13. Measure inside diameter (83) of throttle lever housing (80). Replace throttle lever housing (80) if not within the following limits. REF NO POINT MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 83 Inside diameter of bearing bore 1.3750 (34.925) 1.3756 (34.940) 1.3758 (34.945) 14. Measure inside diameter (84) of two sleeve bearings (85) in fuel shut--off lever assembly (24). NOTE Replace sleeve bearings if not within the following limits. REF NO POINT MEASUREMENT SIZES AND FITS OF NEW PART inches (mm) WEAR LIMITS 84 Inside diameter of sleeve bearing installed in remote control level 0.6270 (15.926) 0.6290 (15.977) 0.6305 (16.015) Figure 47 79 78 81 83 82 80 24 84 84 85 85