TM 9--2815--247--34 0048 00--13 THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS REPAIR -- CONTINUED 0048 00 Assembly 1.   Install two needle bearings (66) and a new plain encased seal (67) in solenoid control housing (44). WARNING 2.   Install solenoid control housing (44) on straight shaft (16) with two flat washers (60 and 65) and two new retaining rings (59 and 64). 3.   Install solenoid stop control (57) on pin (58) in solenoid control housing (44). 4.   Install a new plain encased seal (63) in solenoid housing assembly (12). 5.   Install a new retaining ring (62) on straight shaft (16) and install solenoid housing assembly (12) on straight shaft (16) and over solenoid control housing (44). 6.   Install bearing (61) in solenoid housing assembly (12) and secure to straight shaft (16) with a new retaining ring (62). 7.   Install new gasket (54) and access cover (53) on solenoid housing assembly (12). 8.   Secure access cover (53) to housing assembly (12) using three machine bolts (50), three new lockwashers (51), and three flat washers (52). Figure 47 50 51 52 53 54 61 62 62 12 63 16 64 66 65 44 66 67 60 59 58 57