TM 9--2815--247--34 0049 00--1 METERING PUMP THROTTLE LINKAGE AND ASSOCIATED PARTS REPAIR 0049 00 THIS WORK PACKAGE COVERS: Removal, Disassembly, Inspection, Assembly, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Snap ring pliers (item 44, WP 0103 00) Outside micrometer caliper set (item 9, WP 0103 00) Telescoping gauge set (item 16, WP 0103 00) Spring tester (item 47, WP 0103 00) Safety goggles (item 78, WP 0100 00) Materials/Parts Self--locking nuts (4) (item 49, WP 0102 00) Cotter pins (2) (item 91, WP 0102 00) Lockwashers (item 147, WP 0102 00) Retaining rings (2) (item 117, WP 0102 00) Materials/Parts -- Continued Woodruff key (item 40, WP 0102 00) Retaining rings (2) (item 113, WP 0102 00) Self--locking nuts (3) (item 41, WP 0102 00) Equipment Conditions Engine level on flat surface ( WP 0021 00) Fans, covers, and top deck removed (TM 9--2350--292--20) References: TM 9--2350--292--20 Removal 1.   Disconnect rigid connecting link (1) from remote control lever (2) by removing cotter pin (3) and flat washer (4). Discard cotter pin. 2.   Disconnect control rod assembly (5) from remote control lever (6) by removing self--locking nut (7) and machine bolt (8). Discard self--locking nut. Figure 48 3 2 4 8 5 6 7 1