TM 9--2815--247--34
0064 00--7
ENGINE CRANKSHAFT REPAIR -- CONTINUED
0064 00
Removal -- Continued
20. Place crankshaft (14) on suitable “V” blocks or stand (26) with crankshaft resting on bearing journals.
21. Remove sling (24) from hoist (25) and crankshaft (14).
Figure 6
14
26
24
25
26
NOTE
Do not remove pins from ends of crankshaft unless in-
spection indicates replacement is necessary.
22. Remove seven upper main bearing halves (27) from bearing bores in block.
23. Mark respective locations of bearings (27) on the back of bearing half using a grease pencil; e.g., “1--case”,
“2--case”, etc.
Figure 6
27
27
27
|
|
