|
|
|
|
|
TM 9--2815--247--34
0064 00--16
ENGINE CRANKSHAFT REPAIR -- CONTINUED
0064 00
Installation -- Continued
CAUTION
The main bearing caps and main bearing halves must be
installed in their original position according to location
number identification on the cap and bearing half. The
side of each main bearing cap identified as “fly end” must
be installed toward rear of block. Failure to comply will
result in premature failure.
10. Install seven main bearing caps (9) and lower main bearing halves (13) in position on block studs. Use hand jack
screw (8) to spread block so bearing caps (9) will slide over studs and into position in the block.
11. Remove hand jack screw (8).
Figure 2
9
8
9
|
|
|
|
|
Privacy Statement -
Copyright Information. -
Contact Us
